The University Wiki Service has upgraded the Confluence Server software, from version 5.9.14 to 5.10.8. Please refer to the knowledge base article, KB0015891, for a high level summary of upgrade changes. Thank you!

Page tree
Skip to end of metadata
Go to start of metadata

Susanne Kraft

4/17/09

HOW TO USE THE TELECINE/FILM CHAIN IN 4D CONTROL CMB 4.124A

Note: There are 2 film chains set up. #1 and #2 each one has a projector recording dvcam deck and a monitor. Make sure you are using the corresponding deck/projector

Note: You must have a 400 foot split reel or take up reel to use the projectors. These can be checked out from tech staff (Susanne Kraft or Jeremy Gruy CMB 4.113)

1. Turn on the 2 power strips

2. Turn on the 2 power strips Thread film on to the projector. Thread from right reel to left take up “Split Reel”


 3. Make sure it is threaded as shown here


4. Push button to turn on the “Variac” (located next to the projector) and set to 100% (should already be set) This powers the projector.