The University Wiki Service has upgraded the Confluence Server software, from version 5.9.14 to 5.10.8. Please refer to the knowledge base article, KB0015891, for a high level summary of upgrade changes. Thank you!
Skip to end of metadata
Go to start of metadata

Current version installed on Fourierseq: 1.2.7 by SPHS 6/1/11

Try "man abyss-pe" or "man ABYSS"

Basics of running (straight from the README):

  • Single-end assembly
    Assemble short reads in a file named reads.fa into contigs in a
    file named contigs.fa with the following command:
    ABYSS -k25 reads.fa -o contigs.fa
    where -k is an appropriate k-mer length. The only method to find the
    optimal value of k is to run multiple trials and inspect the results.
    The following shell snippet will assemble for every value of k from 20
    to 40.
    for k in {20..40}; do ABYSS -k$k reads.fa -o contigs-k$k.fa
    done
    The maximum value for k is 64. This limit may be changed at compile
    time using the --enable-maxk option of configure. It may be decreased
    to 32 to decrease memory usage, which is particularly useful for large
    parallel jobs, or increased to 96.
  • Paired-end assembly
    To assemble paired short reads in two files named reads1.fa and
    reads2.fa into contigs in a file named ecoli-contigs.fa, run the
    command:
    abyss-pe k=25 n=10 in='reads1.fa reads2.fa' name=ecoli
    where k is the k-mer length as before.
    n is the minimum number of pairs needed to consider joining two
    contigs. The optimal value for n must be found by trial.
    in specifies the input files to read, which may be in FASTA, FASTQ,
    qseq, export, SAM or BAM format and compressed with gz, bz2 or xz and
    may be tarred.
    The assembled contigs will be stored in ${name}-contigs.fa.
    The suffix of the read identifier for a pair of reads must be one of
    '1' and '2', or 'A' and 'B', or 'F' and 'R', or 'F3' and 'R3', or
    'forward' and 'reverse'. The reads may be interleaved in the same file
    or found in different files. If the mates are in different files, it's
    highly recommended to place each pair of files adjacent on the command
    line and to use an even number of threads. Even if you are running on
    a single-processor machine, using two threads will help performance.
    Do not group together all the files containing the forwards reads
    followed by all the files containing the reverse reads.
    Reads without mates should be placed in a file specified by the `se'
    (single-end) parameter. Reads without mates in the paired-end files
    will slow down the paired-end assembler considerably during the
    ParseAligns stage.
  • No labels