MAINTENANCE OUTAGE: The University Wiki Service will undergo maintenance on Tuesday, September 25th, from 6:00 pm to 8:00 pm.
During this 2 hour time period wikis.utexas.edu may be unavailable.
Users are advised to save content locally that may be needed during this time and to otherwise save all edits as unsaved work may be lost.

Page tree
Skip to end of metadata
Go to start of metadata

Part I: Utilizing the Intercom System to Speak to Room via Ceiling Speaker

The Intercom System is capable of communicating with any room in CMB 1 Behavioral Science Lab which has ceiling speakers. These rooms are Experimental Lab 1 (CMB 1.124), Experimental Lab 2 (CMB 1.120), Experimental Lab 3 (CMB 1.118), Experimental Lab 4 (CMB 1.112A), Experimental Lab 5 (CMB 1.112B), the Focus Group Room (CMB 1.112), and the Natural Viewing Room (CMB 1.115).

Step 1: Locate the intercom on the assigned station and make sure all the buttons are lit.

Step 2: Press and Hold the corresponding button on the intercom to the room of which you would like to speak to.

Step 3: Speak into the microphone while holding the button.

Step 4: Release button when you are finished speaking to participants.  

Part II: Utilizing the Intercom System to Speak to the Research Moderator via IFB

The IFB is an in-ear receiver that permits individual communication from the Control Room (CMB 1.109) Intercoms to the Research Moderator with the IFB Earpiece in any room within the CMB 1 Behavioral Science Lab. These rooms are Experimental Lab 1 (CMB 1.124), Experimental Lab 2 (CMB 1.120), Experimental Lab 3 (CMB 1.118), Experimental Lab 4 (CMB 1.112A), Experimental Lab 5 (CMB 1.112B), the Focus Group Room (CMB 1.112), and the Natural Viewing Room (CMB 1.115).

Step 1: Locate the IFB Belt-pack in the room

The Wireless IFB Belt-pack has a few parts:

  1. Ear Piece (Headphones)
  2. Wireless Receiver (Antenna)
  3. 2 AA Batteries

 
?

Step 2: Turn on the IFB

Below is an image of the IFB Belt-pack when the device is turned OFF:

?

To turn ON the IFB Belt-pack, twist the knob clockwise until you hear a click. Following this click, lights should turn on.
This is an image of when the IFB is turned ON:

*?*

Step 3: Place IFB earpiece in the Moderator’s ear

Step 4: While the Moderator is near, test the “IN-EAR” Intercom communication by pressing and holding the “IN-EAR” button while speaking into Intercom microphone. Release button when done speaking. Obtain confirmation that the moderator can hear you.

?

Step 5: To communicate with the Moderator throughout the Research Session, just Press and Hold the “IN-EAR” button.

Step 6: Release “IN-EAR” button when finished speaking.

 

  • No labels