Sections of this Document
Operation
Standard Cuts
Refer to owner's manual for complete operational instructions. | |
Power on Saw SystemEnsure Start/Stop paddle is "OFF" (pushed in) Turn Main Power Switch "ON" - system will self-check (5-10 sec.) LED displays "READY" (Green On, Red Off)
| |
Adjusting Blade HeightFor through cuts, the blade height should be no more than 1/8-inch - 1/2-inch above the workpiece Loosen the elevation lockknob Turn the elevation handwheel until theblade is at the desired height Turn the handwheel clockwise to raise the blade, and counter-clockwise to lower the blade. Lock the blade height by turning the elevation lock knob clockwise until tight. | |
Adjusting the Blade TiltThe tilt (bevel) angle of the blade can be adjustedbetween 0° and 45° Loosen the tilt lock knob Turn the tilt handwheel until the blade is at the desired angle. Turn the tilt handwheel counter-clockwise to increase the tilt angle, andclockwise to decrease the tilt angle. Lock the tilt angle by turning the tilt lock knob clockwise until tight. | |
Start MotorPull Start/Stop paddle out | |
Stop MotorPush Start/Stop paddle in | |
System Status Codes
|
Frequently Asked Questions
Part #'s, Specs & Operation Manuals
Sawstop PCS31230-TGP252 3-HP Professional Cabinet Saw Assembly - Motor: (all 60Hz, TEFC): 3 hp | SawStop_Getting_Started_With_SawStop_Cast_Iron.pdf SawStop_PCS T-Glide Fence System Owners Manual (Dec 09 - Rev6).pdf SawStop_PCS T-Glide Installation Instructions Poster 12-17-09.pdf |
SawStop TSA-ODC Over-Arm Dust Collection Assembly | SawStop_PCS Over-Arm Dust Collection Installation Guide V1.0 3-23-10.pdf |
SawStop MB-PCS-IND Industrial Saw Mobile Base - Supports saw and extension table | SawStop_PCS_Mobile_Base_Conversion_Kit_Assembly_Instructions.pdf |
SawStop TSBC-10R2 Table Saw Brake Cartridge for 10-Inch Blades | |