Page History

Here is the projector loaded with a reel of film.
This is the final setup and the rest of the wiki will show you
how to wind the film properly.

Image Modified

1. Pull up the arms on the projector you will use the

1. blackcord to hold each arm up as shown here
   

Image Modified

there is a tricky metal flap between the projector arms that needs
to be in this up position to load the film.

Image Modified

Hinged for the loading of film through the gate and unhinged to hold the film flat on gate for projection playback

Put in Hinged position (shown here) for the loading of film through the gate

Un- hinge it to hold the film flat to the gate.

Image Modified

Thread the film through the sprockets following the guide lines in red. Make sure the film sprockets are on the correct side. Only one side of the film has sprockets.

Here is the guide of how to load the film. Follow the red arrows in this diagram as well as the red lined arrows on the projector itself.

Close up of the lower winding path that is confusing

Film out to To Take up reel

Image Modified

Make sure all the gates are locked

1. Upper gate make sure it is closed

Image Modified

1. Make sure the hinge is un-hinged

Image Modified

1. Lower gate should be closed

Image Modified

Final loaded film setup for reference.

Image Modified

This is the lever that controls the film playback. Pull forward to play film forward and all the way over to get the Lamp to turn on.