Make sure the Thunderbolt cable is plugged into the Blackmagic Design Intensity Pro as shown here. |
|
Check that the Thunderbolt cable is plugged into the iMac |
|
Go to the |
|
Go to the Blackmagic Design setting |
|
Click on Blackmagic Design Intensity Extreme settings button |
|
Set the following settings in this frame grab |
|
Open ProTools>File> |
|
Create a blank session |
|
Save to tempstorage |
|
Track>New Track one track |
|
Create a Mono Track |
|
On every track |
|
Set all channels to Stereo Monitor (Stereo) or Stereo Monitor L and or R depending on your needs. |
|
Use this knob for Control Room Speaker Volume |
|
Use the top knob (Phones 1) to control the sound booth headphones volume. |
|
Push this button to select either CR (Control Room) or push again to toggle to HP. |
|
Next, Import the video into the project |
|
Navigate to the video file that you want to view in the ProTools session |
|
Choose to import at Session Start |
|
Connect Mic and Headset in the Sound Booth for Audio talent |
|
When recording audio to eliminate the headphone latency you can turn on |
|
Select A1 as the source for the track you would like to record |
|
Record as needed using normal ProTools recording procedure by hitting play on the transport window while the record button is enabled. |
|
Your track should also be "record enabled" |
|
Should see input levels in ProTools I/O view. Set inputs so the levels are in the green to yellow areas. |
|
If levels are going into red then turn down P1 on HD OMNI hardware |
|
Push and hold this button to talk back to talent in booth |
|
This is where the talkback Mic is located |
|