ProTools - Focusrite RED4Pre Surround Sound setup CMB 4.112A

Choose Configuration 5.1 Surround

>Focusrite Thunderbolt and 5.1 surround config

Each speaker output should send a signal to this cable 

Choose 

Import Settings

Set it to Focusrite Thunderbolt

Click OK

Click on >Setup>I/O

Click on the 5.1 path order and make sure the L, R, C, LFE, Ls and Rs are selected

NOTE IF YOU DON'T SEE 5.1 OPTIONS YOU ARE NOT IN PROTOOLS ULTIMATE CHECK ILOK TO MAKE SURE

YOU HAVE A LICENSE ACTIVE

Select all the ouputs and delete them.

After all the outputs are selected click delete path

Click Delete

Click on "New Path"

Choose to create 1 new track 5.1 and path = Output

The channels will auto populate

Click OK to Apply

Go to >Track>New

Create a mono track and create some pink noise on the track to test

On the new track select a span of the clip to create the white noise on

Go to AudioSuite>Other>Signal Generator

Choose Pink Noise

Make sure the Output is Yellow and set to Output 5.1 output

Go To >Window> Mix or click "command ="

In the mix window on the track with the 5.1 output you will see the "Multi Channel" Panner window Drag the dot to each corner to test the output of the system should hear the correct panning for left, right LS and RS  NOTE IF THE OUTPUTS ARE WHITE THEN THIS WONT WORK THE OUTPUTS HAVE TO BE YELLOW TO GET THE MULTI CHANNEL PANNER TO WORK

To see the Multichannel fader larger click on the mini fader

This will open the surround window

Note to check LFE

Go to Output> OutputLFE You will have to turn up the volume on the crestron to make sure you can hear the LFE on the test