You must have a reservation to use the laser cutter.  Reservations can be made with the desk staff during our open hours.  Laser cutting is $5/hour.

How to Prepare Your File

How to Use the Laser Cutter

Settings/Materials

Lime powder MSDS

Laser Cutter Policies

General

• If

...

• the laser cutter

...

• computers aren't logged in, notify staff at the Technology Desk. Only the

...

• Technology Desk staff are permitted to give you access to the system. Do not

...

• log in

...

• using your own EID credentials, as the software is only configured under our account.
• Infractions of these laser cutter or any other Technology Lab policies will result in privileges being revoked
• Operating the laser cutter without (a) being trained AND (b) paying the subscription fee will result in privileges being revoked

...

• If you notice that the laser cutter requires cleaning or maintenance, please notify the

...

• Technology Desk staff immediately in person or by calling 512-471-1189.

• • Any reservation time lost to maintenance or cleaning will be reimbursed with equivalent time or with returned BevoBucks.

...

Certification and Subscription

• In order to use the laser cutters the student, faculty, or staff must
  • be a member of the School of Architecture community (students, faculty, or staff) AND
  • purchase a subscription for the semester AND 
  • complete online laser cutter training AND

...

• Same-day reservations do not count against your weekly limit and may be reserved without any limits.

...

• • be certified for laser cutter use by a member of the Technology Desk staff.

Health and Safety

• Although this system uses a CO₂ laser that could damage your eyes or skin with direct contact, it uses both a system of safety interlocks and an IR-absorbing window on the top door, making the laser cutter safe to use without goggles or other safety gear.
  • Please note that the intense light that appears during the engraving or cutting process is the product of material combustion or vaporization. DO NOT STARE AT THE BRIGHT LIGHT or risk damage to your eyes.
    • Certain materials require close supervision, but you should still avoid looking directly at the combustion/vaporization.
  • Additionally, the Red Dot Pointer that appears on the material is just a positioning help, not the laser beam itself, however, DO NOT STARE at the Red Dot Pointer or risk damage to your eyes.
  • Lastly, the machine doors are safety-interlocked and will disable the CO₂ laser beam from firing when the doors are opened. The Red Dot Pointer is NOT safety interlocked and can be activated with the door(s) either open or closed.

...

• Operating the laser cutter in any unsafe way can result in
a fine up to the amount of
• damage caused to your health and/or the laser cutter.
(For example, a replacement lens for the X-660 costs $230.)
•  
  • Unsafe practices include
(
• • , but are not limited to
)
• • :
    • Leaving the laser cutter unattended while it is running
.
• • • Cutting materials that are
not
• • • on the
acceptable materials list.
• There will be a $50 fine assessed for operating the laser cutter without a reservation.
There will be a $200 fine assessed for operating the laser cutter without the appropriate training, with another $200 fine for the person who allowed you access to the system.
• • • Prohibited Materials list
      • Many of the Prohibited Materials emit toxic gas

    • Tampering with the laser cutter's safety mechanisms

    • Turning off the Air Assist feature

    • 'Sandwiching' more flammable material between less-flammable materials. (i.e. a sheet of cardboard between two layers of chipboard, etc.) The result could easily be a FIRE!
• IN CASE OF FIRE, IMMEDIATELY PRESS THE EMERGENCY STOP BUTTON (located on top of the laser) AND USE THE FIRE EXTINGUISHER (located near the door). 

Approved Materials

Prohibited Materials